fuel monitors

Showing all 2 results

  • 0 out of 5

    COALESCER FILTER/WATER SEPARATORS

    Two-stage coalescer filter/water separators are the primary defence against fuel contamination by water and dirt. Our coalescer separators provide a complete system that meets industry standards and individual levels of effluent purity required by commercial airlines, major oil companies and governments.

    The coalescer separator housings contain both first-stage coalescer and second-stage separator elements with no internal moving parts. Coalescer elements provide efficient and economical filtration and coalescence of fluids in a wide range of applications in industry and aviation. Our elements provide greater coalescing efficiency and contaminant holding capacity than most conventional coalescers or other separation techniques. As a result, our coalescers improve product quality, reduce maintenance costs and help prevent unscheduled shutdowns. Retention ratings available from 1 to 40 microns.

    The separator elements provide efficient separation of water in a wide range of fluid process streams. Separators are designed for passing fuel and oil and rejecting the large water droplets produced by coalescers. Both Teflon and synthetic separator elements can be cleaned and reused.

    The product is pumped under pressure to flow through the housing inlet chamber and inside/out through the multi-media coalescer element. This specially developed multi-media element configuration traps and holds minute solid particles, while forcing small water droplets to commingle and grow into heavier, larger drops that fall by gravity to the housing sump area. The fuel continues to flow outside/in through the second-stage separator elements. These separator elements strip any remaining water droplets from the fuel allowing only clean, dry fuel to pass.

    Vertical and horizontal housing designs are available with a wide selection of coalescer and separator elements to meet specific applications. Housings are designed for easy servicing and low maintenance with many standard and optional accessories and connections available to facilitate piping and installation requirements.

    Our aviation coalescer separators have been tested and qualified to meet the performance requirements of API/EI Bulletin 1581, Fifth Edition.

  • 0 out of 5

    INDUSTRIAL LIQUID FILTERS

    Since few decades ENEKA has been involved in supply of advanced filtration and separation systems for oil refineries, petrochemical industry, aviation, power generation, marine and other industries. Our scope of supply is including industrial filters, two-stage coalescer separators, fuel monitors, oil/water separators, bilge water separators and other systems designed to separate and treat fluids containing a mixture of water, hydrocarbons and solids.

    Filters

    Filter is a device for the removal of solids from liquids or gases by flowing through a filter media that will retain the solids and allow only clean product to pass through. Hydrocarbon process and fuel filtration are usually employed to remove process contaminants, pipe-scale, transport contaminants and improve the appearance and the acceptance of the product. A single pass of product through the system removes solids such as rust, dirt, scale, granules and other particles commonly found in liquid process streams. Replaceable element-type filters have wide usage and can be used in most any application. The two most important factors to consider when determining what kind of replaceable element type filters to use are (1) the concentration of the solids to be retained by the filter and (2) the required degree of filtration.

    Our range of filters contains API/EI approved filters for use in aviation/jet fuel applications. For certain applications filters are employed as pre-filter up stream of coalescers or filter/water separators to improve the lifetime (and reduce the operating cost) of the coalescing cartridges.

    Our high efficiency filter elements are constructed to meet the demanding requirements of the industrial filter market. For the filtration of fuels and hydrocarbon process-streams we can offer a wide range of filter elements. Our elements are all dimensionally interchangeable and both surface filters and depth filters are available. The filters offer nominal filtration and the filtration degree ranges from 0,5 micron.

    Types of our filter elements:
    • Pleated media filter elements,
    • Pleated media CORELESS elements,
    • Depth type filter elements,
    • Wire mesh elements etc.